MSAccess 2

fapfel · Post by **fapfel** » Thu Jun 23, 2005 7:33 am

In Access the keystrokes ALT-V, Enter, q will take you to the queries tab. Using Robotask Send Keys to active window the syntax would be %(V){ENTER}q. at his point the query that the cursor is on starts running. It is as if there is an implied Enter in Robotask. I get the same effect if I go to the Macro tab. The macro that the cursor is on starts running. I am trying to go to a query and open it in design mode not run it. Any ideas.
Fred

Post by **Oleg** » Thu Jun 23, 2005 8:27 am

Ctrl-Enter opens selected object in design mode.
Try to use ^({ENTER}) combination

fapfel · Post by **fapfel** » Thu Jun 23, 2005 8:34 am

Thank you for your assistance. After opening Access, I had a send keys ENTER to get past the Username Password prompt. It wasn't necessary and was being passed to the object under the cursor at that point.
Fred